This electric longboard skateboard control system has an EMP control module with a remote module, it can do whatever as ESC does, ESC would be easy to damage, this control module would be more stable and paperMade of high quality chip and electronic components, dual drive design can offer excellent and stable performanceThe solid structure of the main board can be significantly longer than the service life With a remote receiver module, so it supports remote control The well organized circuit board is easy to install but needs professional skillsIt comes with a portable controller, it has an economic shape, very compatible to hold and use 4 different speed modes: high speed sport mode, high speed economy mode, middle speed mode, low speed modeWith an LED indicator that displays signal status, speed modes, battery percentageFeatures:Application areas: scouts, wheelbars, torsion cars, balance cars and so onThe upgrade dual motor drive ESC is a double layer board and many better than other ESCWireless 2.4G remote control transmission to control The maximum distance can reach 20 metersAlso, have single/manual motor drive ESC for hub motorSupport 5055/5065/6354/6374/6384 belt motorProtection: Overvoltage, Undervoltage, Overperformance, Stack, CW/CCW, Overcurrent, Speed ControlSpecification:Rated Voltage: 36VCurrent: 12ARotate speed: 4200RPMDrive mode: Dual Motor DriveMax. speed: 35KM/HPower: 430W (36V)Weight: about 250g/8.82 ounceMax. Loaded: 120kg/264.55 lbsRemote distance: 20m/65.62ft (Max.)Sending method:: HallPower connector: XT60 plugHall interface: 5pin 2.0 connectorMotor plug: 4mm BananaSize: approx. 18.5 x 10 x 5cm/7.28 x 3.94 x 1.97 inchInstallations:1: Connect the main control to the power supply2: The power is turned on, wait for two seconds, then press and hold the key for about 6 seconds Wait until the switch indicator flashes3: Turn on the remote control switch and use a small screendriver to press the button inside the small hole in the lower left corner of the remote control4: The remote control is turned off for two seconds and then turned on. Wait for the remote control signal light and the switch signal light to flash at the same time to indicate that the match is successfulPackage includes:1x ESC Substitute Control1x USB to Micro USB Cable1x LED Battery Indicator1x 2.4G Remote Control Transmitter1x Switch