Features Low voltage protection will protect the module and battery from damage caused by excessive discharge when using a storage battery as an input. The power module uses double sendust magnets wound with 1.2mm copper wires. Support reverse input protection with MOS so you don't worry about bad input wire and power failure. Thickened heatsink and intelligent temperature control cooling fan dissipate heat better. Low resistance MOS 100V/210A with large power and current input, suitable for high power LED motors. Features: Type: Non-Insulated Lift Module (BOOST) Input voltage: DC10V to 60V Maximum input current: 30A (input voltage from 10V to 30V) 25A (input voltage 31V to 60V) Rest current: 15mA (will increase when converting from 12V to 20V) Output voltage: 12V to 90V (adjustable, the default is 19V) Maximum output current: 20A (related to the difference in input and output voltage, the larger the voltage difference, the smaller the output current will be. Please improve the heat dissipation when the current is greater than 15A) Constant current range: 0.8A to 20A (+/-0.3A) Reverse Input Protection: Yes (150AMOS) Low voltage protection: Yes (V8 to 50V adjustable, self-recovery) Operating temperature: -40°C to +85°C (If the temperature is too high, please improve heat dissipation) Frequency: 150 kHz. Conversion Efficiency: 92% to 97% (efficiency is related to input/output voltage, current and voltage difference. The smaller the difference, the more efficiency will be) Input over-current protection: yes (automatic protection when input is above 35A and the supply voltage will not increase) Short circuit protection: yes (input fuse 30A) Wiring Method: Terminals (Please use a large current copper wire) Maximum output power = input voltage * maximum current (if input 12V, maximum output power = 12V * 30A = 360W) Size: 130 x 84 x 52 mm/5.11 x 3.3 x 2.04 inches. Package includes: 1 x Module Package List