ORing Seal Rebuild Kit — Booster Pump Kit PB460 (Replacement for Polaris) Restore a leaking or underperforming Polaris booster pump with a purposebuilt Oring seal rebuild kit compatible with the PB460 model. This replacement kit provides the seals and Orings needed to rebuild the booster pump's wetted connections and restore reliable sealing without replacing the entire pump. Key benefits Stops leaks and prevents water loss by replacing worn seals and Orings that cause common pump failures. Restores pump performance and pressure consistency by renewing critical sealing surfaces. Costeffective alternative to full pump replacement— only the parts that need attention. Designed for direct compatibility with Polaris booster pump model PB460 to simplify parts selection. What it does (functionality) Supplies the Orings and seal components required to rebuild the booster pump's sealing assemblies. Replaces aged, hardened, or damaged seals that lead to leaks, pressure loss, or reduced pump efficiency. Allows quick maintenance or field to the pump to service with properly sized seals. Compatibility and fit Replacement kit specified for Polaris booster pump model PB460. Intended as a direct replacement of the original Orings and seals used in that model—verify PB460 before . Key attributes Purpose: Oring and seal rebuild kit for booster pump . Model compatibility: PB460. Application: Replacement seals for Polaris booster pump assemblies. Performance: Returns sealing function to the pump when installed correctly. Typical use cases Leak : deteriorated or cracked seals on a Polaris PB460 booster pump to stop external leaks around housings and fittings. Preventive maintenance: Keep a PB460 booster pump operating at peak efficiency by renewing seals during scheduled service intervals. Field service and pool equipment : Use as a parts kit for pool technicians or DIY maintenance when a PB460 pump shows signs of seal failure or pressure loss. Installation notes Intended for use by technicians or experienced DIYers familiar with pump disassembly and reassembly. all seals and Orings removed during disassembly to ensure consistent sealing performance. Inspect mating surfaces and housings for damage or wear before reassembly; any damaged components as needed. What to check before ordering Confirm your booster pump's model number is PB460 and that the pump requires an Oring/seal rebuild. Compare the kit contents to the parts you need to ; this kit supplies the Orings and seals specified for PB460 rebuilds. This ORing Seal Rebuild Kit is offered as a replacement parts kit for Polaris PB460 booster pumps to restore sealing performance and extend the service life of the pump without full replacement.