Features:Wear-resistant, recyclable.Easy to use in DIY operation.Balance tiles in the same horizontal position.Improve the installation speed of tile.Reduce the fatigue/pressure of installers.There is hardly any crackless, flat surface.It reduces the need for grinding and polishing.Prevent tiles from moving during solidification.Use Tips:Lay the first tile, leaving more than 2mm (with cross gaskets). Close to tile.Insert T-pins along the gap between tiles.Then rotate 180 degrees and the T-needle is stuck at the bottom of the two tiles.Adjust the lid with a hand/special wrench until the two tiles are on the same level.After leveling, about 5-6 hours, before the cement/binder is completely dry, rotate the lid in reverse and take out the 180 degree T needle until the word is removed.Avoid not removing the T-tile leveling system:1. Ceramic tile gaskets are 2mm or more (cross gaskets are recommended)2. When leveling, the cement or tile adhesives around T-type leveller must be cleaned.3. Remove the T-type straightener about 5-6 hours after leveling before the tile binder or cement is completely dried.Specifications:Material: High quality PP stainless steelScope of application: masonryApplicable Brick Gap: 2-6mm/0.08-0.24"Applicable Tile Thickness: 3-16mm/0.12-0.63"Size: 86*30*20mm/3.39*1.18*0.79"Notes:Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!Please allow 1-3mm measuring deviation due to manual measurement.26/78/100 X Tile Spacers1 X Wrench