Product condition: 100% brand new Product material: LED and ABS Plastic Color: blue, green, orange, red and white Quantity: one piece Easy to install, including installation instructions. With the For Honda logo Fitment: For HONDA CB400 (2001-2005) For HONDA CB400SF (1999-2005) For HONDA CB600F (2003-2006) For HONDA CB600S (2000-2002) For HONDA CB900F Hornet (2002-2008) For HONDA CB1100SF (1999-2004) For HONDA CB1300SF (1998-2002) For HONDA CBF500 (2004-2008) For HONDA CBF600 (2004-2007) For HONDA CbR150 (2015 Modify plug) For HONDA CBR250R (2011-2014) For HONDA CBR600F Hornet (1995-2010) For HONDA CBR600F3 (1995-1998) For HONDA CBR600F4 (1999-2000) For HONDA CBR600F4i (2001-2006) For HONDA CBR600FS (2001-2003) For HONDA CBR900RR (1994-2003) For HONDA CBR919RR (1996-1999) For HONDA CBR929RR (2000-2001) For HONDA CBR954RR (2002-2003) For HONDA CBR1100XX (1996-2008) For HONDA 599 Hornet (2003-2006) For HONDA 919 Hornet (2002-2008) For HONDA X 4 (1997-2003) For HONDA X 11 (1999-2004) (If you encounter any questions, please be sure to contact me first, please do not leave negative comments first, I very much hope to answer your questions, thank you) -Product installation and setting methods. You need to setup this module after installation.Perform the setup only when the engine is WARM so the idle speed is normal,Find a long,straight road with light traffic.The unit does not learn the same gear twice,this makes it easy to set up on the road.You can even shift down and stop during the setup if needed.Do not stare at the display,watch the road and ride with extreme care as always! -Turn the ignition On.The display counts backwards(6 to 1)indicating that the memory is clear. -When "L"is flashing,stare the engine in Neutral and let the engine idle. -The display will blink "1".Select first gear, release the clutch, and keep the RPM above idle speed. The display is blinking faster while the unit is learning the gear. -When the display shows "2", select second gear. -Repeat this process until all gears are thought (5 or 6). -The unit is programmed and should indicate the gears correctly. -Now, when ignition is turned on, the display counts forward (1 to 6) indicating that it is fully functional. Product installation instructions and pictures: Locate the connector under the fuel tank or under the seat The green cable connects to the motorcycle crankshaft sensor cable If you have any questions, you can contact me. Thank you