Item Type: DC Voltage Regulator_x000D_Material: Organic silica gel + aluminum_x000D_Model: CDL122425_x000D_Input Voltage Range: 12V (DC10-20V)_x000D_(long-term 500W, maximum 720W)_x000D_Output Voltage: 24V_x000D_Rated Output Current: 25A_x000D_Output Power: 600W_x000D_Protection Level: IP67_x000D_Conversion Efficiency: Up to 96%_x000D_Working Temperature: -20~+80_x000D_Installation Line Length: Approx. 18cm / 7.1in 1Possess automatic protection functions such as overcurrent, overvoltage, overheating, short circuit, etc. When the protected circuit enters an unsafe value, the built?in protector automatically cuts off the circuit, and resumes normal operation when the value returns to the normal range 2Provide all?round protection, more stable and reliable. Boost converter is designed with potting and waterproof technology, 3The use of organic silica gel potting has waterproof, dustproof and shockproof effects, therefore suitable for use in various harsh environments 4Suitable for LED car display, surveillance camera, electric fan, water pump, motor, photovoltaic energy numerical control equipment, water pump, router, ADSL modems, switches 5Can be used for LED lights, digital photo frames, electronic refrigerators, portable DVDs, stereos, security systems, portable tools, printers, network equipment, various industrial electrical equipment with corresponding voltages, etc. 1 xDC Voltage Regulator 1 x Wiring Drawing 1. In order to ensure the normal operation of the converter within the input voltage range, the input voltage must not be lower than the minimum or maximum input value restricted by the product during use, and the input voltage value must be higher than the output voltage value by more than 2V. If there is no voltage difference of 2v, the output value will be lower, but it will not damage (affect) the use of the converter._x000D_2. The input current must be greater than or equal to the required power of the output load device (for example, if the power of the load device needs 100w, then the input power must be greater than or equal to 100w). When the converter is in use, the current of the load device should not be greater than the maximum current value that the converter can withstand, and leave as much margin as possible for the converter to ensure that the converter works normally and achieves the highest conversion efficiency._x000D_3. The positive and negative poles of the converter cannot be reversely connected during use. Reverse connection may cause damage to the converter. It is recommended to add a suitable fuse to the input terminal during use._x000D_4. When there is no load, the chip works in light load mode, and the output voltage may vary within a certain range._x000D_5. Please note that the new type and old type of this product will be sent randomly,and make sure you will not mind before ordering.