Item Type: Tool Setter Material: Alloy steel Tool Setting Speed: 50-200mm per minute Contact Service Life: 3 million times Positioning Accuracy: 0.001mm Power Supply Voltage: DC5-24V, current below 20mA (maximum), when with LED lamp, the current should be limited below 10mA Ambient Temperature: 0 to 80 Protection Level: IP67 (100% waterproof, oil proof sealing) Note: Mechanical: 1. When the tool setting instrument is directly installed on the workbench with guaranteed spindle, right angle and parallelism, the installation surface shall be cleaned and fixed with bolts. 2. When installing on other planes, find out the right angle and parallel surface of the mounting surface. 3. When using protective cover, pay special attention to the position of the used contact surface, right angle, repeatability of parallelism, temperature change of installation guide rod, and rigidity (related to the weight and contact force). Electrical: 1. Contact rated DC+24V 10% 20mA (maximum) 2. When the machine body is grounded, the tool setting instrument should be installed at the side of the ground wire during connection. 3. When connecting the tool setting instrument with LED, pay attention to the polarity (+) (-). Recommended value: 10mA, resistance load. There are three main forms of chip prevention: 1) Jet Pipe A. Blow off the chips and coolant attached to the contact surfaces and tools. The grease and foreign matters that cannot be blown off and stick to the contact parts shall be cleaned frequently. B. The screw joint at the tip of the air pipe will be damaged when the tool and cutting chips are strongly impacted. C. The inner diameter of the air pipe passage shall be set at more than 2. 2) Protective Cover A. In the environment with cutting chips, if a rubber cover is used to protect the cutting chips and coolant, which will hinder the operation of movable parts after accumulation, then a protective cover is required. B. There are fixed (or detachable) and automatic switch types, can be used by the customer according to the situation. 3) Cleaning A. The cutting chips and oil stains attached to the contact (super hard) that are difficult to blow off with air should be cleaned with alcohol. B. Around the rubber cover, the clearance between the rubber protective cover and the air pipe, and the accumulation of cutting chips outside the protective cover may hinder the movement and return of the rubber. Please clean it. C. Do not open the inside of the rubber protective cover.