1、There are 12 million high light transmission wide‑angle lens, support uncompressed video and AVI format 1080P high‑definition resolution video 2、With a back clip design and a strong magnet attached to the back, having the characteristics of light weight and small size, which is convenient for carrying and recording 3、Using 180° infrared rotating lens, the infrared light can rotate with the lens to meet your needs 4、Adopt high-speed Type-C interface to ensure higher charging efficiency and faster reading speed 5、Supports 120‑degree ultra‑wide‑angle camera, supports OTG connection, and can be played on mobile phones at any time 1 x Body Camera1 x User Manual1 x Card Pin1 x USB Cable1 x Cleaning Towel Item Type: Body CameraProduct Size: Approx. 94 x 33 x 8mm / 3.7 x 1.3 x 0.3in (manual measurement, allow 1‑3cm/ 0.4‑ 1.2in error)Video Format: AVIVideo Encoding: M-JPEGCamera: 1200WResolution: 1920 x 1080P/1280 x 720P (optional)Video Frequency: 30fpsSupport System: For Win Me/2000/XP/2003/vista/OS X/Linux/Win7/8/10Charging Voltage: DC-5VBattery Capacity: Lithium Battery 1050mAh (built-in battery shipped)Image Ratio: 16:9Video Working Time: 8.3 HoursRecording Working Time: 18 HoursInterface Type: Type-CStorage Type: Support T-Flash Card 8-256GB (high-speed card recommended) (without memory card)Lens Angle: 120° Super Wide Angle 4. Take a photo: In standby, short press the "photograph button", the blue light is off and the green light is on until the save is complete, and then the green light is off and the blue light is on. 5. Motion detection: In the standby mode, press and hold the "photograph button" for 2 seconds to enter the motion detection mode to record. When the light change is detected, the machine will enter the recording state, and there will always be light changes. The minute is automatically saved once, and the blue indicator light will light up as a reminder. When there is no light change, it will return to the motion detection standby mode. At this time, long press the "photograph button" for 2 seconds to return to standby mode.Note: In the motion detection mode, except long press any button except the camera button, the blue and green indicator light flashes 3 times and goes out. You can know that the machine is in motion detection standby mode. If the indicator light does not flash, the machine is already in standby mode. Shut down. Motion detection saves a file in 2 minutes, and the indicator will flash once every time it is saved. 6. Turn on/off the infrared light: In standby, press and hold the "recording button" for 2 seconds, the green light is on, and the infrared light is on. When entering infrared video standby, the infrared light is turned on first, and the infrared light cannot be turned on when it is already in the working state. 7. Reset: When the product does not respond, you can use the card pin to stab the reset hole and the machine can shut down and work normally. 8. PC camera: When the memory card is not inserted, it can be used as a PC camera when connected to a computer. 9. In standby mode, it will automatically shut down without any operation for 5 minutes 10. When the power is low, the blue and green lights flash alternately, each flashing 10 times, and then shut down 11. When there is no card, the blue and green lights flash 5 times at the same time, and then shut down. 12. If you use OTG to connect to mobile phones, TVs, tablets and other devices to connect to playback, there is a message that the memory card is damaged and cannot be recognized. When you need to format the memory card, you can connect to the computer for playback, because there are many mobile phone systems, which may be formatted by the machine. It will cause the phone to fail to recognize the memory card, but the files are still stored on the memory card normally. Please refer to the computer at this time. Please use the data cable to connect to the computer to play back the files.