Durable: these metal hold brackets are made of reliable metal materials, strong, durable and lightweight, easy to install and less likely to deform or break; They are suitable for blinds or windows and can serve you for a long timeAppropriate size: It is suitable for blinds and does not take up too much space; Before ordering, please check the size carefully and make they can match your windows or blindsSimple design: blind hold brackets are simple in design, small in size, thus, they are difficult to be noticed; Using to hold blinds will not affect the overall appearance of the blinds, and you can enjoy the beautiful scenery from the windows as Easy to apply: the installation and application of these are rather easy and convenient; Firstly, you put the pins into the holes of the brackets, and then reinforce and you can successfully apply ; For more details, please refer to the installation steps belowProper ans simple appearance: These metal hold brackets are simple in design, small in size, thus, they are difficult to be noticed. Using to hold blinds will not affect the overall appearance of the blinds, and you can enjoy the beautiful scenery from the windows as .Installation procedures:1. What you need: drill, screwdriver, tape measure, hammer, pencil.2. If the bottom rail is not fitted with pins, drill a approx. 1/2 inch deep 7/64 inch or 3/32 inch bit in the center to hold pins on both sides of the rail.3. Punch the pins in.4. Put the blind plate , put the bottom rail flat in place, and mark the position of the fixed bracket with a pencil.5. Screw the bracket to the door.6. Measure the position of the bracket now screwed to the door and mark on the other side.7. Then repeat the above steps to installthe second bracket.colour: silverMaterial: metalSize: About 42x32.2mmPackage Contents:4 x Hold brackets With screws4 x Pin boltsOnly the above package content, other products are not included.Note: Light and different displays may the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.