Features: brand new and high quality The PDB-XT60 has been engineered to provide the highest possible performance and reliability in a 36x50mm & 4 layers PCB. It distributes power from a LiPo pack to 6 ESCs, as well as providing synchronised & regulated DC 5V outputs & linear regulated DC 12V for powering Cameras, Servos, RC receiver, Flight Controllers, Video Transmitters, LEDs, etc. It offers a XT60 socket to connect the LiPo pack conveniently. 2oz copper, 4-layers &1.6mm PCB. Built-in XT60 Socket. Total 6 pairs ESC solder tabs are fit for H or X type frame. 5V & 12V Output LED indicators & Short circuit tolerant. Specifications: - Input voltage range (3S-4S LiPo operation): 9 - 18V DC - Regulated 5V and 12V outputs - LED power indicators ( 5V & 12V outputs ) - 6 ESC outputs & 1 pair VCC/GND pads ESC outputs: - Continuous current: 25Ax4 or 15Ax6 - Peak current (10 seconds/minute): 30Ax4 or 20Ax6 BEC 5V output: - Designed for RC Receivers, Flight controllers, OSD, and Servos. - DC/DC synchronous buck regulator. - Voltage: 5.0 +/- 0.1VDC - Continuous current: 2 Amps (Max.2.5A 10s/minute) - Output Ripple: 40mV (VIn=16V, VOut=5V@2A load) - Short-circuit tolerant (5 seconds/minute) BEC 12V output: - Designed for Video TX or FPV camera with linear regulator. - The battery should be 4S LiPo (13~18V DC) - Voltage: 12.0 +/- 0.3VDC - Continuous current: 500mA (Max.0.8A 5s/minute) - Short-circuit tolerant (2 seconds/minute) BEC 12V @ 3S LiPo - Output voltage= 3S LiPo voltage -1V Physical: - Dimensions: 36 x 50 x 4 mm (without XT60) - Mounting: 30.5 x 30.5mm, 3mm - Weight: 7.5g(w/o XT60), 11g(w/ XT60) Note: Please allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you! Package includes: 1Set x Power Distribution Board