Item Type: Stepper motor driver_x000D_ Model: TB6600 upgraded version_x000D_ DC Power Supply: 9V-40V DC power supply_x000D_ Eight Kinds of Output Current Available: Maximum 4.0A_x000D_ 6 Subdivision Modes Available: 32 subdivisions_x000D_ Standard Common Positive Single Pulse Interface: Yes_x000D_ Offline Hold Function: Support_x000D_ Protection: Built-in temperature protection and overcurrent protection_x000D_ Weight: Approx. 201 g / 7.1 oz_x000D_ Applicable Stepper Motors: 42, 57 and 86 type 2 phase 4 phase (4-wire 6-wire 8-wire)_x000D_ Definition of Terminal:_x000D_ Signal Input:_x000D_ CP+: Pulse signal input positive terminal._x000D_ CP-: Pulse signal input negative terminal._x000D_ DIR+: Positive end of motor forward and reverse control._x000D_ DIR-: The negative end of the motor's positive and negative control._x000D_ Enable+: Positive end of motor offline control._x000D_ Enable-: Motor off-line control negative terminal._x000D_ Motor Winding Connection:_x000D_ A+: Connect the A+ phase of the motor winding._x000D_ A-: Connect the A-phase of the motor winding._x000D_ B+: Connect B+ phase of motor winding._x000D_ B-: Connect B-phase of motor winding._x000D_ Working voltage connection:_x000D_ Volt Current Condenser: DC power supply is positive (note: 10V VCC 42V)._x000D_ Ground: Negative DC power supply_x000D_ Signal Input: Optocoupler isolation connection_x000D_ Two Connection Methods for Input Signal Interface: The user can adopt the common anode connection method or the common cathode connection method as needed._x000D_ 1. Common Anode Connection Method: Connect CP+, DIR+ and EN+ to the power supply of the control system respectively. If the power supply is +5V, it can be directly connected. If the power supply is higher than +5V, an external current limiting resistor R must be added. To keep that the drive current of 8-15mA is provided to the internal optical coupling of the driver. The pulse input signal is accessed through CP-; at this time, DIR- and Enable- are active at low level._x000D_ 2. Common Cathode Connection: Connect CP-, DIR-, Enable- to the ground terminal of the control system (SGND, isolated from the power ground); the +5V pulse input signal is added through CP+; at this time, DIR+, Enable+ are in Active high. The connection value of the current limiting resistor R is the same as the common anode connection method.