DC MOTOR REGULATOR DC10-55V 60A Feature: 1. LCD display with backlight with the ability to display working time, speed percentage, current mode, do front and do rear. 2. Slow start and slowdown time can be set za by setting the lower limit of the upper speed limit. 3. Manual automatic two modes are optional, and automatic mode is fully automatic positive and negative rotation at the set time. 4. The tact switch do switching do front and do rear, acceleration and deceleration in yoga mode, solves the easy do breaking the problem of the traditional potentiometer. 5. You can set the total working time, stop at a fixed time. Specification: Article type: DC motor controllerli> Input voltage:DC10-55Vli> Output voltage:linear under loadli> Momentary current:60Ali> Continuous current: within 40Ali> Speed control type:Current adjustmentli> Speed control mode:Jogging -li> Speed range:0-100%li> Control frequency:15 KHZli> Cable type: fence terminal blockli> Auxiliary motor:brush motorli> Opening in panel:length x width 129 x 81,5 mm /5,08 x 3,21 inchesli> Digital speed display:Percentage 0-100li> List of packages: 1 x DC motor controllerli> The input must be positive and negative, the input voltage should be equal to the rated voltage of the motor (in the range of 10-55 V), and the input of 220 V will burn. li> Function settings: The settings for function 0-1-2-3-4-5-6-7-8-9 are as follows:li> Manual selection of automatic mode. Function 0:1 is manual mode, 2 is automatic mode. By default, this is 1 manual mode. li> Slow start time setting. Function 1: 000 - 100 Slow start time do 100% speed is adjustable in the range of 0-10 seconds. The default value is 1 second. li> Slow stop time setting. Function 2: 000 - 100 The slow stop time can be adjusted in the range of 0-10 seconds. The default value is 1 second. li> Lower speed limit setting. Function 3:000 - 080 The minimum speed is adjustable in the range of 0-80% and is less than the maximum speed setting. The default value is 0. li> Setting the upper speed limit. Function 4:000 - 100 The maximum speed is adjustable in the range 0-100% and is greater than the minimum speed setting. The default value is 100%. li> Setting acceleration and deceleration values. Function 5:001 002 0050 010 015 020 020 025 Each press of the plus or minus button changes the speed by 1%, 2%, 5%, 10%, 15%, 20%, 25%. li> Total engine runtime setting Function 6: minimum 1 second - 99 hours 59 minutes and 59 seconds maximum. The default value is 99 hours 59 minutes 59 seconds. li> Following function 7.8.9. This is a time setting in fully automatic mode. li> Time setting do front Function 7: minimum 1 second - maximum 99 hours. The default value is 10 seconds. li> Stop time setting Function 8: minimum 1 second - maximum 99 hours. The default value is 10 seconds. li> Reverse time setting Function 9: minimum 1 second - maximum 99 hours. The default value is 10 seconds. li>