Eyewash Station Set 304 Stainless Steel Emergency Eye Wash Shower Combination Tool for Factory Laboratory Item Type: Eye Wash Station Set Product Material: 304 Stainless Steel Design Pressure: 0.8MPA Sealing Pressure: 0.45MPA Working Pressure: 0.2-0.4MPA Shower Water Output: ≥75.5L/mIN Eye Wash Water Output: ≥11.4L/mIN Water Inlet Size: G1-1/4 Inch Female Thread Outlet Size: G1-1/4 Inch Female Thread Standard: Strictly follow the technical requirements of US ANSI Z358.1 2004 for production. Switching Method: Manual Switch (can be equipped with high performance pedal, hand foot linkage, more convenient and fast operation) Application: Widely used in nuclear power, power station, pharmaceutical, medical, chemical, petrochemical, electronics, metallurgy, smelting, printing, dyeing, education and scientific research units, etc. Installation: 1. Directly installed on the ground of the work site, near hazardous work areas, at a distance of no more than 15 meters. The time to arrive at the eyewash in a straight line shall not exceed 10 seconds. When the chemical substance splashes on the eyes, face, neck and body of the staff, the eyewash shall be used in a timely manner for major flushing to reduce injuries and gain valuable time 2. Non explosion proof electrical switches are not allowed within the 2m radius of the eyewash 3. No obstacles shall be stacked within a 2 meter radius of the eyewash 4. Eyewash cannot be installed across floors 5. Must be connected to drinking tap water 6. According to the installation hole position of the eyewash base, drill 3 holes with a diameter of 10mm on the ground where the eyewash needs to be installed, and fix them with stainless steel wall plug. 7. According to the assembly parts drawing of the eyewash, the whole eyewash parts shall be installed one by one. The water pipe connection must use a sealed thread seal tape. 8. During the installation process, it is best to have a 90 degree angle between the sprinkler head, eye wash elbow, and water outlet.