1) PREPARATION - Make sure the item has been stripped of grease, dirt and gunks and other stuff that may interfere with the adhesion of . Durability of any hydrographics coat depends upon complete and careful preparation of the surface before painting. The surface should be even and smooth. Any cracks, and holes or any other imperfections do not let the paint adhere correctly to the surface. Inadequate surface preparation results into majority of failures.2) PRIMER PAINT - Use the appropriate primer for your substrate. It may depend whether its a metal, plastic, fiberglass, ceramic or wood. Consult your local paint shop for the best option with your market .3) PAINTING THE BASECOLOR - Paint your preferred basecolor. Most of the patterns are transparent so it a color of would greatly affect your overall output.4) ACTIVATION & DIPPING - Lay the film in the water. Make sure the 'sticky side' (try to wet your fingers and Press both sides of the film) of the film is at the bottom. Meaning it should be Pressing the surface of the water. Remove creases/folds or underneath the print by blowing it lightly. Wait 60-80 seconds before activating it. Spray the activator as consistent as much as possible and without too much disturbance on the water.5) WASH - Wash your dipped item using a running water to the sticky residues left by the print and let it dry for a while.CLEARCOAT - Spray the clearcoat to protect your print and item once its dry. It would be whether its a gloss, a semi-gloss, or a flat .Usage: Use to water transfer printing technology.size:50cm x 100cm, thickness is about 0.03mmMaterial:PVAcolour:purplePackage Contents:1 x Water transfer hydrodipping filmOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.