Specification:Type: light curing composite resinShage: A1 A2 A3Net weight: 2.5gCol: as picture showQuantity:1pcsFeatures:1. Low polymerization shrinkage.2. High strength polishability.3. Similar modulus of elasticity with dentine.4. Radioopaque fluide releasing Optimal polishability high shade stability.5. Easy to mold.6. Easy to adhere to bracket f thodontics.7. Simple convenient to use.8. Used f all types of cavity preparations. Usage:1. Prepare cavities accding to conventional requirements, remove decayed tissue, clean cavities.2. Apply dental composite resin pre-treatment agent (etchant) to the tooth surface to be bonded, rinse blow dry the bonding surface.3. Apply a unifm thin layer of dental composite resin pre-treatment agent (adhesive) on the bonding surface, illuminate with a dental light curing lamp f 20 seconds.4. After filling carving with an appropriate amount of composite resin, the light intensity should not be less than 400mW or cm The light source is irradiated f 20 seconds to solidify. Curing depth 1.5mm. If the filling depth is large, the irradiation time can be appropriately extended layered solidification filling can be carried out.5. Conduct trimming polishing, inspect with dental bite paper befe trimming. It is recommended to use rubber polishing wheels ultra-fine abrasive polishing strips.6. Recommended use of pulp protection cushioning materials: calcium hydroxide (light cured chemically cured) other non oily cushioning materials. Do not use materials containing eugenol directly as a base.Scope of application: Non occlusal cavity filling repair.Attention: Close the lid immediately after use to avoid exposure to light.Contraindications: F pulpitis, use with caution. When penetrating the pulp near the pulp chamber, it is necessary to perfm pulp capping pulp protection surgery befe filling with resin. Other pulp diseases should be treated befe filling.Stage conditions: Ste at room temperature avoid direct sunlight.