Gas Filling:1. Fill , and make sure the switch is turned off at OFF, then supplement. 2. Guide the gas tank into the air hole, and press down to inflate. 3. After about 10 seconds, gas filling can be completed. Wait a few minutes until the gas is stable before use. 4. If there is a hissing air out sound at the tail after the gas is injected, it can be eliminated by slightly pressing the pen tip into the air inlet. Colour:As Shown;Material:Silicone + Metal Ignition: 1. Replace the soldering 2. Push the switch to the ON position and hear a "hissing" sound 3. Push the electronic switch to . 4. Burn for 3 minutes after ignition,and the soldering iron continue to heat when the fire is extinguished. 5. Adjust the flame size; 6. The temperature of this product is as high as 1300 (the temperature of the soldering iron is 450 ). Pay attention to when using it. After using it,turn the switch to the OFF position. 7. When using the gas soldering iron,please pay special attention to wait until the flame is completely eliminated and the objects inside the soldering iron become red,so as to extend the life of the soldering iron . Precautions: 1. Replace the connector after cooling or replace it in advance. 2. The adjusting button can control the gas output and temperature,usually in the middle position. 3. After use,store it after cooling,and do not place it in high temperature or direct sunlight. 4. Please use high-quality canned gas to fill,and keep away from the fire source when filling. 5. It is necessary to clean the nozzle frequently because of the gas or slag. 6. When cleaning,the nozzle can be pressed on the gas outlet of the gas tank to achieve cleaning effect. Package Contents: 1 * Soldering pen 1 * Plagiocephalia 1 * Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.