Feature: 1. High‑end CNC handwheel, finely crafted, has excellent quality and good performance. 2. High‑quality plastic material, hard, corrosion‑resistant, and has long service life. 3. 5V, 100PPR, A A‑ B B‑, suitable for 98% of Chinese systems, to better meet your needs. 4. Small, compact, easy to carry and operate, can bring you more convenience. 5. Well‑made, excellent quality, higher work efficiency, and bring you a better experience. Specification: Condition: 100% Brand NewItem Type: HandwheelMaterial: PlasticColor: As the Picture ShownEncoder Specification: Power Supply Voltage: DC5±10% Pulse Number: 100PPR Output Voltage (VH) (Maximum): ≥3.8V Output Voltage (VL) (Minimum): ≤0.3V Output Current: 80mA Model Format: A.B.A-.B- Output Resistance: DIFF Response Speed: 5KHz Current Consumption: 50mA Starting Torque (Maximum): 150g Axial Volume (minimum): R 2kg±10% Rotation Life (minimum): 1KKR Operating Temperature: 0℃/+50℃ Storage Temperature: -10℃/+70℃ Operating Humidity: 35-80% Vibration Resistance: 0.5G Heavy Strike Resistance: 2G.Wiring Table Specification: Output Signal: A B V0 V+ A- B- Terminal-Line Driver A: 1 2 3 4 5 6 Instruction: YP800-100B-1L represents a large handwheel with a diameter of 80mm, the output is 100 pulses, the working voltage is 5V, and the output mode is long-line output. This product is suitable for CNC machine tools, two orthogonal output signals (A, B), 100 pulses , The output mode is long-line drive. Package List: 1 x Handwheel1 x Instruction3 x Terminal Note: 1. The encoder is a precision instrument. It is forbidden to knock, drop, bump, etc. during installation. Improper installation or use will affect the performance and service life of the encoder.2. Pay attention to the shaft load of the encoder during installation, and must not exceed the limit load.3. Be careful not to exceed the limit speed of the encoder during use. If the speed exceeds the limit, the electrical signal of the encoder may be lost.4. The wiring must be correct. If the wiring error will cause damage to the internal circuit of the encoder, the unused cable shall be insulated before the initial starting.5. Maximum response frequency limited maximum speed.