BSIDE ESR02 Pro Digital SMD Transistor Tester Inductance Meter for System Components . BSIDE ESR02 PRO DIGITAL SMD TRANSISTOR TESTER Characteristic: 1. Key operation, boot test, key to get. 2. Large LCD display with backlight function for easy reading. 3. Automatically test the pin elements and display them on the LCD display. 4. Automatic detection of components such as NPN bipolar transistors, PNP, MOSFET with N and P channel, diodes (including dual diodes), thyristors, transistors, resistors and capacitors, etc. 5. It can detect polarity voltage in the direction of transistor emitter conduction, MOSFET protection diode and gain reference coefficient. 6. Measurement of MOSFET gate threshold voltage and gate capacity. . BSIDE ESR02 PRO DIGITAL SMD TRANSISTOR TESTER Specification: Brand: BSIDE Model: ESR02 Pro Resistor: 0 Ω 50 Ω, resolution: 0.01 ohm Capacity: 25 pF 100 mF, resolution: 1 pF Inductance: 0.01mH20H, resolution: 0.01mH ESR Capacitor Resolution: 0.01 Ω Battery: 1 pc. x 9V 6LR61 battery (NOT included) Black color Size: approx. 14*8*4.5cm/5.5*3.1*1.8inch Weight: about 214 g/7.5 oz Use of instructions: Press “POWER/TEST” to turn on and start the test. With this button, you can repeat multiple measurements. Automatic shutdown occurs 20 seconds after measurement. Provide three kinds of sockets, each pin 1, pin 2 and pin 3 sockets are connected. The location of the device does not require the order of instructions, and the screen displays the component function of each pin after measurement. On the back there is a table “typical ESR value of electrolytic capacitor”, it is only for information purposes. These are typical values for a standard electrolytic capacitor at room temperature. Calibration: Close the test pins 1, 2, 3 together and press the “POWER / TEST” button, then the screen will be prompted to go to calibration. Press the button again within 2 seconds to confirm. A few seconds later, the screen will prompt you to release pins 1, 2, 3, release them and wait for the calibration to complete. . BSIDE ESR02 PRO DIGITAL SMD TRANSISTOR TESTER List of packages: 1 x transistor tester 1 x User Manual Note: Before testing the capacitor, it must be discharged, otherwise the internal circuit may be damaged. If you use DC power supply, choose 9V12V DC power supply. (including 9V and 12V) It can be powered by 9V 6LR61 battery (NOT included), when the battery power drops below 6V, it should be replaced with a new one. . BSIDE ESR02 PRO DIGITAL SMD TRANSISTOR TESTER