Application: the MAX4466 microphone breakout is suitable for voice converters, audio recording and sampling, and audio response projects using FFT; On the back, there is a small trimmer pot to adjust the gain; You can set the gain from 25x to 125x Parameters: power supply voltage: +2.4V to +5.5V (can be compatible with STM, Raspberry Pi and other development board motherboards); Power supply rejection ratio: 112dB; Common mode rejection ratio: 126dB; AVOL: 125dB (RL = 100 thousands of ohm meter) rail-to-rail output; Quiescent power supply current: less than 24 microamp; Gain bandwidth: 600kHz 20-20KHz electret microphone soldered on: comes with a 20-20KHz electret microphone soldered on the board for audio-reactive projects; It is recommended to use the FFT driver library, which can take audio input and ' late' it into frequencies Easy to use: connect GND to ground, VCC to 2.4-5VDC; For the good performance, use the 'quietest' supply available (this would be the 3.3V supply) Power supply noise rejection function: the amplifier has good power supply noise rejection colour: purple Material: ABS Package Contents: 10 x Amplifier for microphone Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm. Product Notes: Please allow a little manual errors.Due to the lighting of the photos and the difference of monitors, the pictures may not reflect the actual color of the real item. Please confirm acceptance before ordering. About Shipping: Please ensure your shipping informations are correct to avoid delivery issues. All orders are shipped within 3 days after payment. Delivery usually takes 8–12 days, The specific delivery time is depend on circumstances. If you have any questions during your purchase, feel free to contact us. We will respond you within 24 hours.