- Simplify your panel clamping process with our innovative 4-way pressure clamping system. This design applies simultaneous pressure from the top, bottom, and sides, ensuring a perfect bond. - Eliminate the challenges of traditional pipe and bar clamps, which often fail to provide adequate pressure on all sides, leading to warped or bent panels. Our system addresses this common issue effectively. - The unique 4-way pressure mechanism pulls inward on all four sides, distributing even pressure across your panels. This prevents warping, bending, or twisting during the gluing process. - Create clamps of any length with durable plastic 4-notch bars, offering maximum adjustability for various stock widths. The clamp accommodates boards up to 6 inches thick by adjusting the clamp width capacity using the notches. - Easy to use: Turn the handle clockwise to tighten and counterclockwise to release pressure. Side pressure pads protect your stock from damage while providing a secure hold. - Ideal for a variety of projects: Attach wide boards, shelves, table tops, and more. Simply mount the clamps to any length of 2 x 2 lumber (ripped 2" x 4" boards) with the included wood screws, apply wood glue, position the clamps on your panels, and tighten using the handle. - For optimal results, place a 4-way pressure clamp every 12 to 18 inches. - Each package includes two complete 4-way pressure clamp assemblies, featuring: 2 swivel handle assemblies, 2 tail assemblies, 4 side pressure pads, and 12 4-notch bars. This setup allows you to create two clamps, making it ideal for projects longer than 12 inches. - Note: Wood is required for installation but is not included with the clamp set.