Well waterproof performance, fast temperature rising, temperature uniformity,High thermal efficiency, well toughness Easy to use Using range: All kinds of automobile fuel tank, water tank, storage battery, anti-freezing heat insulation Wire length: 210cm Voltage: 220 v, 250 w Installation: Use pressure-sensitive adhesive to on the flat and smooth artifacts The maximum service temperature of pressure sensitive adhesive: 150Celsius Continuous temperature, 230Celsiusinstantaneous temperature. Power density is less than 0.9 W/c ㎡ Silicone rubber heater with pressure sensitive adhesive should be used in half a year after processing, otherwise it influence on the performance of the glue using Instructions: The electric heating device must pay attention to use, its working temperature should be less than 240 Celsius, the continuous use instantaneous does not exceed 300 Celsius. When the work temperature less than 240 Celsius, the current density is up to 3 w/c ㎡ Paste the type installation conditions, allowed working temperature less than 150 Celsius Working voltage selection with high power high voltage, low power low voltage for the principle, special needs can be exceptions. Plug Type:EU Plug,it applies to Indonesia, Germany, France, Spain, Italy and so on colour:Orange Material:Silicone Rubber size:9 x 13cm Package Contents: 1 x Car heater tank Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.