1、Suitable for CR-10 3D printer bed hole. 2、The operating temperature should be lower than 200 °C for continuous use. 3、Rapid heating, low power, high temperature, uniform heat transfer, long life and high thermal efficiency conversion. 4、Adhesive for 3M is easy and convenient to install. 5、The silicone pad heats up quickly, please take anti-scalding measures. Features: 1. Suitable for CR-10 3D printer bed hole. 2. The operating temperature should be lower than 200 °C for continuous use. 3. Rapid heating, low power, high temperature, uniform heat transfer, long life and high thermal efficiency conversion. 4. Adhesive for 3M is easy and convenient to install. 5. The silicone pad heats up quickly, please take anti-scalding measures. Specification: Color: Orange Material: silicone rubber (with 3M adhesive) Size: about 300*300mm/ 11.81* 11.81inch Voltage: 220V Power: 300W Package List: 1 * Hot Bed Silicone Pad Note: The limit temperature of the silicone heating plate is about 200 degrees (the temperature of the silicone material is resistant to temperature), and the heating plate is more likely to be burned out. The silicone heating plate can not be put into the water, and it doesn't matter if there is a few drops of water on the surface during use.