Description: Drive LCD on for DUE by just plugging into for DUE main board, no flying wires Compatible with 40-pin version LCD, which is commonly used in DUE shield, and comptabile with 32-pin version LCD, which is commonly used in development board On board SD card slot, SPI flash footprint with adjustable CS selection,for upgrade include font IC to draw text to the LCD and also support SPI Flash library LCD power 3.3V and 5V selectable through solder jumpers Pins are routed to reduce CPU cycles, display speed is faster Specification: Material: Plastic Size: 50x35mm/1.97x1.38in The shield is compatible with for DUE and the following LCD: 2.2" LCD module (220x176) 2.8" LCD module (320x240) 3.2" LCD module with font IC (320x240) 3.2" High resolution LCD module with font IC (480x320) 3.5" LCD module with Font IC (480x320) (Full viewing angle IPS panel) 4.0" LCD module with Font IC (480x320) 4.3" LCD module with Font IC (480x272) 5.0" LCD module with Font IC (800x480) 7.0" LCD module with Font IC (800x480) Package Includes: 1pc /SD Shield Expansion Board Note: LCD in a much faster speed using 84Mhz Ardiuno DUE The shield route all the LCD data pins to port PC1-PC8 and PC12-19, control pins to PD0-PD3,this design can acheive high speed data transfer (three cycles per write strobe to the LCD) to maximize LCD display speed The SPI interface (for SD or flash control) is route to the ISP header of for DUE,so that high speed SPI transfer with DMA can be achieved