1This module is used when the actual operation requires isolation control and voltage conversion. 2It can realize 3.3V or 5V to control the interface of 3.6--24V voltage level. After the control terminal is turned on, the controlled terminal will also be turned on. 3Photoelectric isolation has strong anti-interference ability. Can drive big behindPower triodes, MOS tubes, etc., where high voltage driving is required, can also directly drive low power 24V relays. 4If it is a pulse signal, please note that the limit of 817 is below 4KHZ. If the control signal is greater than 4KHZ, please do not use this module, it will not work properly. 5Through the jumper cap can achieve whether the output is high potential output or low output. Features: 4. If it is a pulse signal, please note that the limit of 817 is below 4KHZ. If the control signal is greater than 4KHZ, please do not use this module, it will not work properly. 5. Through the jumper cap can achieve whether the output is high potential output or low output. 6. The 4th and 817 on the board are independent, which can realize simultaneous control of different voltages, etc. Specification: Condition: 100% Brand New Material: ABS The jumper can reach the exit gate: high potential or pull the exit pad Package list: Notes: 1. The actual product color may deviate from the photo due to light. 2. There may be a slight deviation in the measurement of product.