Suits remote models: PTX5 PTX-5 Compatibility: DCB-05 (Dual Gate Controller) GDO-6v3 (EasyRoller) GDO-6v4 (EasyRoller) GDO-7v2 (SecuraLift) GDO-7v3 (SecuraLift) GDO-8v3 (Shed Master) GDO-9 (Dynamo) GDO-9v2 (SecuraLift) GDO-9v2 (Enduro) GDO-9v3 (Dominator) GDO-9v3 (Dynamo) GDO-10v1 (Toro) GDO-11v1 (Ero) NES-24v1 (NeoSlider) SGO-1 (Elite) *Not compatible with GEN2 motors(grey case with grey buttons) or motors installed after 2015 Please Note: These remotes are NOT compatible with PTX-4 (433Mhz) with blue case. It is NOT compatible with older ATA motors which still use SecuraCode 433MHz or old 27MHz TX remotes without the use of Tricode receiver card. Please ensure that your original remote is pictured and your motor model number is listed to ensure compatib Note: This remote control is not compatible with the blue ATA PTX-5V2 Included * Remote Control * Battery * Keychain * English Manual Programming transmitters to receiver The remote control is the same function as your original remote.it should programming with original receiver according to your original Manual when you get it. 1. Locate the Learn / Code Set button on the motor. This is usually under the lamp cover, or on the back of the motor. 2. Press the Learn / Code Set button once, then let go. A light should illuminate. 3. Press the desired transmitter button once, and the light will go out. 4. Press the remote again the the light will flash on the motor and then go out, signifying the remote has been coded. 5. Test the operation of the remote.