Features 1Numerical control adjustment precise and fast can be boosted or stepped down output voltage 0.530V arbitrarily adjusted limit current 04A arbitrarily adjusted. 2Input terminal anti reverse protection reverse connection will not burn the output ripple is small with type filtering. 3Anti backflow at the output terminal no need to add an antibackflow diode when charging the battery 4Possess a variety of software protection mechanisms the protection threshold is adjustable thicker heat sink more stable module performance 5After the module's operating parameters exceed the protection threshold the output is automatically turned off. Specification Item Type: Power ModuleMaterial: ABSOutput Current: 0-4A/0-5AOutput Power: 35W4KX)/80W(5KXCurrent Display Resolution: 0.001AConversion Efficiency: About 88%Compatible: For Electronic Equipment Mechanical Engineering Motors Package List 1 x Power Module Note In order to ensure the accuracy of calibration calibration voltagevoltage above 12V can start calibration; calibration currentcurrent above 1A can start calibration.1. Module input IN must not be shortcircuited with output OUT otherwise the constant current function will fail.2. Please make sure that the power of the power supply is always greater than the power required by the output load!3. If the module wants to output at full load the input voltage must be above 8V. When the input voltage is 5V the output power is about 15W. The maximum current value of the module is 4A provided that it is limited by the maximum output power for example when the output is 17V the current should not be greater than 2A.4. When using this module over 3A 35W please strengthen heat dissipation5. The module has an input undervoltage protection function the default is about 4.8V (can be set) when the value is lower than this value it will automatically disconnect the output (note that the voltage at the module port is lower than the undervoltage protection threshold when the input current is compared When it is large don't ignore the partial voltage on the input wire).