Properties:1.Using highly transparent eco-friendly PET material as base material to better recognize the markings in the model markings.2.DSP IAE's unique printing technology: A scale linear is printed at a distance of 1mm on the surface of the marking tape, which is convenient for positioning when marking.3.Special thickened material: It can be applied seamlessly to different model parts, there is no degreasing and adhesive residue.4.Double-layer hot melt adhesive: The printed scale line is placed between the bottom and the top layer of adhesive tape, and the two layers of adhesive tape are fused together by the unique hot melt adhesive technology, so that the scale line does not fall off and is not scratched by external force.5.Multiple sizes engraving tape to meet more engraving requirements. Combining the engraved lines has a better effect.The special acrylic adhesive is used as adhesive material, which becomes stronger when glued and leaves no adhesive residue when torn off.6.Strong ductility and viscosity: It can also be freely used on model parts with curved surface, and the tape will not fall off due to insufficient adhesion.Instructions:1. First prepare the parts to be engraved. First, design the milling with a pencil. After setting the engraving position point, mark the position point with a carving knife or a marking needle.2.Cut off a piece of positioning tape, glue one side of the tape along the pre-drawn notch line, and use the scale on the notch tape to determine the distance of the notch line.3.Use a push or hook knife to gently pull the tape along the side of the marking tape from one point back to the other. Repeat this process until the scratching is complete. Remember not to use force so as not to interfere with the scratching. Effect.4. After the label is finished, the label tape can be removed. The recommended time for gluing the label tape to the part should not exceed 30 days, otherwise environmental influences can cause adhesive residues when detached.Scope of delivery:1* DSPIAE CG Series Carving guide tape