Eachine TX805 5.8G 40CH 25/200/600/800mW FPV Transmitter TX LED Display Support OSD/Pitmode/Smart Audio Precise details: -Specification of VTX: Brand name: Eachine Model: TX805 Item name: FPV Transmitter VTX Frequency: 5.8G Channels: 40CHInput voltage: 7V~24V 5V camera supply: 120mA(MAX)----25mW@12V 5V camera supply: 200mA(MAX)---- 200mW@12V 5V camera supply: 300mA(MAX)---- 600mW@12V 5V camera supply: 350mA(MAX)---- 800mW@12V Extra features: Smart audio Power supply: 5V output for Camera Output power: 25mW/200mW/600mW/800mW switchable Antenna connector: MMCX Cable connector: Solder pads Dimensions: 36mm*22mm*5mm,30.5 stackable hole Weight: 8g(excluding antenna) -Features: 1. Pitmode 2. Support Smart audio 3. 40 channels with MIC 4. Power failure memory 5. 25/200/600/800mw power switchable 6. Support OSD Configuring via Betaflight FC 7. One button frequency and power setup 8. 724V wide input voltage with 5V for camera,12V typical corresponding current value: 25mw-120mA 200mw-200mA 600mw-300mA 800mw-350mA 9. Solid MMCX antenna connection and MMCX brass dipole antenna -Button control Channel select mode -Channel select Select channels by simple short presses. Blue LED light on stands for CH1,short presses to change 8 channels sequentially. For CH2/3/4/5/6/7/8,Blue LED flicker once,it won't light on. Notice:Blue LED only light on for CH1 -Band select Press button for 2S,Red LED will flash,then short presses to select 5 bands. -Power select Press button for 4S,Red LED will flash,then select power by simple short presses to select 25mW/200mW/600mW sequentially,For 200mW, Green LED flicker once,it won't light on;For 600mW Blue LED flicker once,it won't light on .Press the button again ,Red LED,Green LED and Blue LED lights together,Represents the highest power 800mW. Notice:Red LED only light on for 25mW. -Pit Mode(0.01mW) While in Pit Mode you can change channels and set power levels , but none of these changes will take effect until you quit Pit Mode.By default ,Pit Mode will send a very weak signal. Two ways to exit pit mode: Press button 12S until all 16 LED turned off and light on again to exit pit mode,or you can exit pit mode via Betaflight OSD. Notice:The VTX has memory for settings,To change the settings ,please repeat steps as above. -Package included: 1 x Eachine TX805 5.8G 40CH 25/200/600/800mW FPV Transmitter VTX 1 x Adapter connector cable (RPSMA or SMA Female) 1 x MMCX Pigtail Antenna 1 x Instructions