- 160x128 TFT display - Multi function key - Transistor test area - Zener Diode test area - IR receiver window - Micro USB Charging Interface - Charge indicator LED 1.1 Features TC-V2.12k is a TFT graphic display Multifunction Tester. l Transistor Tester - - Automatic detection of zener diode 0.01-30V - Self test with automatic calibration l IR decoder - Support Hitachi IR coding - IR waveform display - Infrared receiving instruction l Other - Measurement results using TFT graphic display(160x128) - One key operation - Auto Power Off(Timeout Settable) - Built-in high capacity rechargeable Li-ion Battery - Li-ion Battery voltage detection - 160x128 TFT display - Multi function key - Transistor test area - Zener Diode test area - IR receiver window - Micro USB Charging Interface - Charge indicator LED 1.1 Features TC-V2.12k is a TFT graphic display Multifunction Tester. l Transistor Tester - - Automatic detection of zener diode 0.01-30V - Self test with automatic calibration l IR decoder - Support Hitachi IR coding - IR waveform display - Infrared receiving instruction l Other - Measurement results using TFT graphic display(160x128) - One key operation - Auto Power Off(Timeout Settable) - Support Chinese and English Warning: Built-in Li-ion Battery, it is strictly prohibited the tester immersed in water, or near a heat source! Warning: For your personal safety, please strictly comply with the use of Li-ion Battery specifications and precautions! 1 Operating Instructions 1.1 Key operational definitions Multi-function key has two actions: l Short pre: Pre the key and not le than 10 ms, release key within 1.5 seconds l Long pre: Pre the key more than 1.5 seconds 1.2 Power on In the power off state, short pre the multifunction key, the tester is turned on and automatically measured. l Power on &measurement interface 1.3 Detect transistor In the power off state or the test is completed, put the test element into the transistor test area of test seat, and pre the locking handle, short pre the multifunction key, the tester automatically measure, graphical display of measurement results when testing is complete. Warning: Always be sure to DISCHARGE capacitors before connecting them to the tester! The tester may be damaged before you have switched it on! Warning: We do not recommend using the tester to measure the battery! The battery voltage must be le than 4.5V, otherwise the tester may be damaged! l Component placement Test seat are p>