This instrument has four interfaces: single point measurement, scanning, system information, correction and calibration. The default into single-point measurement interface. Aluminum alloy shell prolongs service life. Note: For the of the , each time calibration correction will automatically change to the calibration. Meanwhile, in order to the integrity of the calibration, the calibration process, the automatic shutdown function fails, the . Attached video is to show the way to open the device .The buttons on the panel, 1234 from left to right, need to press 2 and 4 at the same time. Startup & Shutdown: Hold down the CTRL key off press the power switch button. The state, long press (2S above) the switch button, after the release, the instrument will shut down. The state, long press (2S above) the switch button, after the release, the instrument will shut down. Advice when Using: In order to the accuracy of measurement and calibration, preheat the instrument at least 15 minutes. Try to use good quality RF cable and . Model No.:PS100 Working Frequency: 137.5MHz~2.7GHz Stepped Frequency: 1kHz Display: 2.4inch TFT with resolution 320*240(QVGA) Power Consumption less than 1.5W Charging Current: 400mA Charging Port: USB Auto Power Off: Settable 5-60minutes Measured Parameters: Impedance, reactance, SWR and S11 Resolution: 4-digit readings Frequency Accuracy: less than +/- 10ppm Connector: SMA-K Impedance Measurement Range: 1 ohm~1000 ohm @frequency less than 1300MHz; 1 ohm~300 ohm @frequency more than 1300MHz (Impedance Absolute Value) Standing Wave Measurement Range: 1~65 @frequency less than 1300MHz; 1~10 @frequency more than 1300MHz S11(dB)Measurement Range: 0dB to -50dB Error (Single-point measurement): For Impedance: less than Impedance absolute value x 5% +/- 0.1 ohm (Z less than 200 ohm, less than 1.5GHz) For Standing Wave: less than Effective readings x 10% +/- 0.1 For S11: 0.1dB/5 (0dB to -10dB) For (dB/): 1dB/10 (-10dB to -20dB); 5dB/20 (-20dB to -40dB) Directivity: less than 35dB (140MHz to 2GHz after calibration); less than 30dB (2GHz to 2.7GHz) Scanning Points: 280 Output Level: -18dBm Working Temperature: 0 to 40 Atmospheric Pressure: 860hPa~1060hPa Colour: black Material: Aluminum alloy Package Contents: 1 * PS100 Antenna Analyzer SWR Meter with data cable Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.