Feature: 1. Imported good-quality motor steel sheet, bearing made of German craftsmanship, possess low self-inductance and good responsiveness 2. Can be directly connected to the load and run at low speed without gear reduction when it is close to the locked-rotor state, so a high torsion to inertia ratio can be generated on the load shaft, and the system error caused by the use of reduction gears can be eliminated 3. The inner rotor adopts German technology, and the surface is coated with imported rotor glue to prevent burrs on the surface after the carbon steel is oxidized and ground, causing the motor noise to increase 4. The front and rear covers are perfectly connected, the body is black electrophoresis, high-end and generous, and the body size is standard 5. Quick start and stop, frequent CW and CCW, accurate control, the number of pulses determines the position of the motor Specification: Item Type: Stepper Gear Motor Material: Carbon steel, silicon steel, copper Step Angle: 1.8° Step Angle Accuracy: ±5% Resistance Accuracy: ±10% (20℃) Inductance Accuracy: ±20% (1KHz) Temperature Rise: 80 ℃Maximum Insulation Resistance: 100MΩ Min, 500VDC Withstand Voltage: 500VAC/Min Radial Maximum Load: 75N Axial Maximum Load: 15N Radial Clearance: 0.02 Maximum Axial Clearance: 0.08 Maximum Ambient Temperature: -20℃ ~ +50℃ Technical Data: Gearbox Motor Model Step Angle Motor Length(approx.) Current Holding Torsion Resistance Inductance Moment of Inertia Weight(approx.) Number of Outgoing Lines Reduction Ratio (E)deg L/mm A/phase N.m Ω/phase mH/pase g.cm² Kg Lead FY56EL300A-TLF514J 1.8 76mm / 3in 3 1.5 2.4 8.5 460 1.2 g / 0.04 oz 4 1:05 FY56EL300A-TLF1014J 1.8 76mm / 3in 3 1.5 2.4 8.5 460 1.2 g / 0.04 oz 4 1:10 FY56EC350A-TLF1014J 1.8 82mm / 3.2in 3.5 2.2 0.9 3.0 520 1.5 g / 0.05 oz 4 1:10 Reducer Parameters: Gearbox series Series Reduction Ratio Length（L1）mm(approx.) Rated Load Maximum Load Efficiency Back Backlash Noise TLF Level 1 3、4、5、7、9、10 53mm / 2.1in 6.0N.m 12N.m 96 ≤15 ≤45 . Package List: 1 x Stepper Gear Motor Note: 1. When connecting the motor to the driver, do not connect the wrong phase.2. Correctly select the reducer model and reduction ratio according to the accuracy required by the machine.3. Due to the different driving conditions, the motor may have obvious heat generation. The surface temperature of the motor is not allowed to exceed 85℃ during operation.4. When installing the motor, be sure to use the front end cover of the motor for positioning, and pay attention to the tolerance matching to ensure the concentricity of the motor shaft and the load.