AUTOOL BT-360 Battery Tester The tester is compatible with batteries: Acid / Lead (regular) AGM flat Spiral AGM Gel EFB 5 languages available including POLISH (English, Dutch, Chinese, Japanese) The AUTOOL BT360 battery tester allows you to measure: battery voltage inrush current internal resistance of the battery operation of the alternator Power standards CCA 100-2400 JIS 26A17-245H52 DIN 100-2200 IEC 100-2200 EN 100-1400 SAE 100-2400 GB 30-220Ah BCI 100-2400 MCA 100-2400 CA 100-2400 Battery test Boot Test Charging Test Device presentation: Comparison of Autool BT360 with testers of a much higher price: Specification: Working Environment Temperature: -10 * C to 50 * C Housing material: acid-resistant ABS plastic Battery Capacity Measurement Range: 30Ah-220Ah Voltage / Application: 12V Input voltage: 9V 15V Battery condition measurement results in%: SOC - battery charge status SOH - battery wear level The kit includes: AUTOOL BT360 tester User manual in Polish There is no need for additional batteries and accumulators to power the device, because it draws its power via clamps directly from the tested car battery. Cable connection: red () black (-) Thanks to advanced electronics, this device has capabilities comparable to expensive professional workshop testers. And even better. The device works immediately after connecting to the tested power source. Detects bad batteries. Protection against wrong polarity connection. Bad connection will not break the tester / battery / car. Direct battery test with charging drops. There is no need to fully charge the battery before testing. The battery test is mainly focused on the analysis of the service life by calculating its current capacity and the degree of wear. It allows you to judge whether the battery needs to be replaced. Thanks to the test, you will assess whether the battery supplies the car with the appropriate current when starting and running the engine. The charging test allows you to analyze the vehicle's charging system to see if the voltage in the electrical system is correct. Advantages of the AUTOOL BT360 tester Simple and easy to use Test the battery in and out of the vehicle Large, easy to read LCD display Test results based on JIS, EN, DIN, SAE and IEC standards Vehicle starting system testing: cranking time, voltage and condition Vehicle charging system test: load voltage, unloaded voltage AH range: 30-220AH Device dimensions: height: 12.7 cm width: 7.6 cm thickness: 2.3 cm length of measuring cables: 53 cm A CERTAIN WARRANTY TECHNICAL SUPPORT GOOD QUALITY GOODS POST-WARRANTY SERVICE IN POLAND