Product parameters Product model:ZFX-W2062C Product Name:Intelligent high precision digital humidity controller Control humidity range:1%RH-99%RH Load power:10A/DC12V/24V Humidity measurement range:1% RH-999% RH measurement error: 3% RH (good environment temperature is 25) Control humidity accuracy:1% RH display:1% RH Humidity return:adjustable between 1-50% RH Supply voltage:DC12V/24v Output type:10A relay output Probe type:humidity resistance sensor Size:48*29*22mm (long * section * high) Installation hole:46*27m Moisture control object:dehumidification or humidification Probe line length:1.5m line length Working environment:humidity 90% RH no frosting Parameter code and settings Code Description range Factory settings P0 Humidification/dehumidification H/C C P1 Backlash 1-50%RH P2 Set the maximum limit 99 95 P3 Set the minimum limit 1 5 P4 Temperature correction -10 10 P5 Delayed start 0-10 1 P6 Restore Factory settings ON- OFF OFF Setting instructions Connect the power supply and load to power the controller. The red color above shows the humidity, blue below. Also red) is displayed as the desired humidity, and pre STG (+) ENT (-) to set the required humidity After the setting is completed, wait for 3 seconds to automatically confirm the return. At this time, the controller automatically performs relay energization according to the setting. For 10A relays, to meet high power loads, please make sure the line is correct. Indicator light, digital tube status description Indicator light:off means the relay is off, steady light means the relay is closed Digital tube:The above shows that LL is the sensor open circuit, indicating that HH is out of the measurement range, the humidity will forcibly open the relay. Display - for ultra high humidity protection. Parameter function description Pre and hold SET for 5 seconds to enter the main menu settings, pre SET (+) ENT (-) to switch P0-P8, when adjusting parameters P0-P8 parameters If you need to adjust P0, pre SET button (+) ENT (-) at the same time, adjust 0K, then control SET (+) ENT (-) Once confirmed, P1-P8 and P0 set the parameters in each code according to their own needs. Panel settings: Wiring diagram: More Products Please Click Below: Category List For Arduino DiY For Raspberry Pi Wirele Module Step UP/Down Module ESP8266 Series CH340 Series Relay Switch Tools Temperature Controller Voltmeter Ammeter USB Tester LED/LCD Modules Sensor Converter & Regulator DC/AC/Stepper Motor Signal Gengerator Development Expansion Board