<p>[Product Introduction] X1002 is a PCleM.2 NVMe protocol M.2 solid-state drive expansion board designed specifically for 5 and installed on the bottom of for 5. It supports NVMe protocol M.2 interface hard drives, high-speed reading and writing, and fast Data transfer and ultra-fast startup</p> <p>The X1002 hardware has on NVME SSD capacity, depending on for .</p> <p>If you find that you cannot start or the hard disk cannot be recognized,</p> <p>1: Please check the power supply and whether the spring pin of X1002 is aligned with the Pi5 chip;</p> <p>2: Check the wiring. The FFC cable is directional. Please check whether the words on the cable are connected correctly; 3: Please update your firmware, refer to the user manual</p> <p>[About hard drive]</p> <p>Tested to be incompatible with the following hard drives:</p> <p> SN550\/SN580 series</p> <p>WD Green SN350 series</p> <p>WD SN850 series</p> <p>Other NVMe SSD drives feature the same Phison controller</p> <p>These specific models have demonstrated compatibility issues and it is recommended to avoid them when considering the X10xx series NVMe expansion boards.</p> <p>[Supports NVMe hard disk protocol]</p> <p>Support 2230\/2242\/2260\/2280 NVME M2 SSD disk. Only 2280 hard drive installation screws are provided, hard drive installation screws of other lengths need to be prepared by yourself;</p> <p>[Support M2 SSD]</p> <p>Material: PCB</p> <p>colour: Black</p> <p>Package Contents:</p> <p>1 x Kit</p> <p>Only the above package content, other products are not included.</p> <p>Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +\/- 1-3cm.</p>